NetLink Enterprises, Inc
Shipping Restrictions & Safety Information

Stun Guns

Shipping Restrictions: Ship only to credit card billing address or verified and registered shipping address.  

No Shipments Outside USA

STATES  with STUN GUN restrictions: HAWAII MASSACHUSETTS MICHIGAN NEW JERSEY NEW YORK RHODE ISLAND WISCONSIN

CITIES with STUN GUN restrictions: ANNAPOLIS, MD BALTIMORE, MD BALTIMORE COUNTY, MD CHICAGO, IL DENSION, IA / CRAWFORD COUNTY (*According to Sheriff Tom Hogan*) DISTRICT OF COLUMBIA PHILADELPHIA

SAFETY WARNING

YOUR STUNGUN WILL NOT WORK UNLESS YOUR READAND FOLLOW THESE INSTRUCTIONS CAREFULLY!

INSTALLING AND REPLACING BATTERY

1.      Use 9 volt Nickel-Cadmium or 9 volt Energizer alkaline batteries.

2.      Remove battery cover plate by sliding it to either side.

3.      Hold the unit so your fingers and body are away from the switch and contact probes.

4.      Snap battery into battery clips.

5.      Place battery in compartment.

6.      Replace battery cover.

Your unit is now fully operational. Keep battery fully charged.

TESTING

Make certain that no part of your hand or body is closer to the contact probes than the switch and safety zone plate. (A distance of approximately 1 1/2".)

Getting closer to the contact probes than this can result in your receiving a mild shock.

When you press the switch, a charge will fire across the front of the unit between the test probes. You should see and hear an electrical discharge between the two inside electrodes.

It will continue to fire as long as you hold the switch in, and will cease firing the moment you release the switch and allow it to return to its' normal position.

Fire a test charge for only 1/2 second duration.

WARNING: DO NOT DISCHARGE THE UNIT INTO THE AIR FOR MORE THEN ONE SECOND AT A TIME AS REPEAT FIRING FOR LONGER DURATIONS CAN DAMAGE UNIT AND VOID WARRANTY.

KEEP AWAY FROM CHILDREN